Get social with us

Recommend this page on:

Test and Debug Boards

OC Output Test Jig

This board allows you to test the programming of your eight open collector outputs from either the Multi-S or Mini boards.  

  • Board has 10 segment bar led.  One led tests power.  One led is unused while the remaining leds indicate the output states of the driver board.  
  • Board has RJ50 jack requiring a 10p10c cable and connector.  Is pin compatible with the jacks on the Multi-S and Mini boards.
  • This resistors on this board are for a 5 VDC power and signal lines.
  • There is space for a 2X5 pin header if you wish to use this board for other purposes.
  • Comes as a DIY kit only.
OC Output Test Jig User Manual
OC Output Test Jig Schematic Rev 1.0.pdf
Adobe Acrobat document [16.0 KB]

Switch Input Test Jig

This board allows you to test the digital inputs of either the Multi-S or Mini boards.  All switches pull input lines to low (ground).

  • Board has RJ50 jack requiring a 10p10c cable and connector.  Is pin compatible with the jacks on the Multi-S and Mini boards.
  • There is space for a 2 X 5 pin header if you wish to use this board for other purposes.
  • Comes as a DIY kit only.
Switch Input Test Jig User Manual
Switch Input Test Jig Schematic Rev 1.0.[...]
Adobe Acrobat document [18.3 KB]

Stall Motor Test Jig

This board allows you to test the stall motor drivers of either the Multi-S or Mini boards.

  • 8 bicolor leds indicate normal and reverse orientation.  Green is for normal while red is for reverse.
  • Uses two RJ45 (ethernet) jacks to plug directly into the Multi-S or Mini boards.
  • Comes as a DIY kit only.
Stall Motor test Jig User Manual
Stall Motor Test Jig Schematic Rev 1.10.[...]
Adobe Acrobat document [29.5 KB]
Print Print | Sitemap
Copyright 2017 Windhaven Consulting